starship Sphenocorona
Explore the galaxies in Starship Sphenocorona.
Project Info
Paper required: two sheets 8.5 x 11 inch (or A4)
Finished Project size: 4.5 inches (11 cm)
Difficulty Level: beginner
INSTRUCTIONS
STEP 1
Print the Starship Sphenocorona pattern onto the two matching paper sheets of your choice.
Read the pattern key included in the General Instructions.
Step 2
Cutout the five pattern pieces by cutting on all black lines; one of Part 1, two of Part 2, and two of Part 3.
Photo 1. Inside of Parts 1, 2, and 3 after Step 2
Photo 2. Outside of Parts 1, 2, and 3 after Step 2
STEP 3
On each of the five parts, fold the red lines as mountain folds and the green lines as valley folds. I highlighted my small craft landing bay (two triangles on Part 1) in yellow; and my propulsion system (three rectangles on each Part 3) in purple.
Photo 3. Inside of Parts 1, 2, and 3 after Step 3
Photo 4. Outside of Parts 1, 2, and 3 after Step 3
Step 4
Complete Part 1. Glue Flap A to the other Flap A, Flap C to the other Flap C, Flap E to the other Flap E, Flap H to the other Flap H, Flap J to the other Flap J, Flap F to the other Flap F, Flap G to the other Flap G, Flap D to the other Flap D, Flap B to the other Flap B, and Flap K to the other Flap K.
Step 5
Complete the two Part 2’s. On each, glue Flap H to the other Flap H, Flap K to the other Flap K, Flap F to the other Flap F, Flap J to the other Flap J, Flap G to the other Flap G, and Flap A to the other Flap A.
step 6
Complete the two Part 3’s. On each, glue Flap Q to the other Flap Q, Flap P to the other Flap P, Flap O to the other Flap O, Flap C to the other Flap C, Flap R to the other Flap R, Flap S to the other Flap S, Flap T to the other Flap T, and Flap B to the other Flap B.
Photo 5. Parts 1, 2, and 3 after Steps 4, 5, and 6
Photo 6. Parts 1, 2, and 3 after Steps 4, 5, and 6; Another View
Step 7
Connect each Part 3 to a Part 2. Glue Flaps L, M, E, N, and D on Part 3 to the similarly labelled flaps on Part 2.
Photo 7. Project after Step 7
Photo 8. Project after Step 7, Another View
Step 8
Complete the Starship Sphenocorona by attaching each Part 2/3 assembly to Part 1. Do this by gluing the square face on each Part 2/3 assembly to one of the square faces on Part 1.
Photo 9. Completed Starship Sphenocorona, View 1
Photo 10. Completed Starship Sphenocorona, View 2
Photo 11. Completed Starship Sphenocorona, View 3
Photo 12. Completed Starship Sphenocorona, View 4
Another Example
Photo 13. Another Completed Starship Sphenocorona, View 1
Photo 13. Another Completed Starship Sphenocorona, View 2
Parts 1 and 2 of this starship are slightly modified sphenocorona, Johnson Solid #86.